How do i reset tire pressure senser on 2004 chevy suburban z71? - suburban tire pressure
if something like the restoration of the Impala, tower in the key position or launching. Once done, then the parking lights on and off times. be reset. Make sure that inflation before you is so true. Good luck!
Thursday, January 14, 2010
Suburban Tire Pressure How Do I Reset Tire Pressure Senser On 2004 Chevy Suburban Z71?
2 comments:
by their owners in the manual, there are two ways that you can do or take to a dealer takes about 15-20 minutes
1. Turn off the ignition with the engine.
2. Apply the parking brake.
3. Turn off the light switch from OFF to parking lamps 4 times in 4 seconds. A double horn chirp sounds and flashes the indicator of low tire pressure indicator has been activated the TPM learn mode.
Warning: The inflated tires can cause injury or damage to tires and wheels. If the tire pressure increase does not exceed the maximum inflation pressure as indicated on the sidewall.
Important If a horn chirp does not sound after 35 seconds for one of the 4 sensors, turn off the ignition of the learning mode and repeat step 1 to finish.
4. Starting with the left front tire to increase or decrease tire pressure for 8-10 seconds, or until a horn chirp sounds. Singing horn may occur before the pressure increase of 8.10 seconds / delay reduction is achieved, or to increase until 30 seconds after the pressure of full-time 8.10 seconds / reduction has been achieved.
5. After the song sounded the horn, go to step 4 for next 3 sensors in the following order:
5.1. Right front
5.2. Right Rear
5.3. Left Rear
6. Having learned all the sensors, exit the learn mode by running the motor.
7. Was abandoned after the learning mode, adjust all tire pressures to the recommended kPa / psi.
Post a Comment